Forums Splitboard Talk Forum voile hardware and loose straps on burton bindings Viewing 4 posts - 1 through 4 (of 4 total) Author Posts February 9, 2006 at 2:59 pm #567480 mergs 100 Posts hey gang, this is hard to explain but i’ll try. wish i took a phot as you now how many words a pic is worth. 🙂 the voile hardware as you all know raises the binding off of the board about a 1/2 inch or so and the bindings, at least my missions are wider than the voile plates. this means that, if i am not paying attention, the toe straps can: a) move around when your feet are not in the bindings (e.g. if you are carrying the board). this is not a huge problem but its an extra thing to check. b) potentially could drop out. frankly i think this is a longshot as the clearance would not make it likely, but it makes me nervous. i dontt like them hanging there in the breeze like they do. so, the biggest annoyance is really “a” bc the toe cap straps i use only stay down on my toe when the straps are in the second position rearward towards the heel. when they move up to the forward position, which it always seems to do, the angle is funky and it tends to make the cap strap pop off the top of the boot. just like flipping the chinese hooks, its another bloody thing to check at the transistion. 🙁 i wish i had a picture, i am sure this makes no sense. 🙁 these problems do not occur on a std board bc the bindings are mounted flush against the board. so i am looking to mc guyver something up tonight, but was wondering if anyone else ran into this, and solved it. February 9, 2006 at 4:43 pm #586533 Tophervw 203 Posts Big Ass Zip-Tie around and under the point on the binder where the strap end pokes out of the bottom of the binder…or the “duct tape”….. 😆 February 9, 2006 at 5:46 pm #586534 mergs 100 Posts @tophervw wrote: Big Ass Zip-Tie around and under the point on the binder where the strap end pokes out of the bottom of the binder…or the “duct tape”….. 😆 zip ties and duct tape! cool, i love ghettin ghetto with my gear! 😉 and if needed, i can always tear a piece off my jacket… for an emerg field repair. most of my jackets are torn up on the rt side and the duct tape is all that is keeping the snow out. 😆 February 10, 2006 at 2:17 am #586535 karma surf 191 Posts When I started splitting I had burton Missions, and lost one of my toe straps on one of my first tours. Since then, I just use silicone, or shoe goo underneath and it works great. With your boots off of your feet, put your boots in your bindings, and crank the straps tight. Make sure your straps have the proper location, angle, etc. Then leave your boots in place, flip the bindings upside down, and cover the toe straps starting point with shoe goo or silicone. Let it dry overnight, and this treatment should last for a looooooong time. Viewing 4 posts - 1 through 4 (of 4 total) You must be logged in to reply to this topic.