Forums Bindings slider pin on plate Viewing 3 posts - 1 through 3 (of 3 total)Author Posts November 29, 2009 at 8:51 pm #572408 mtengaio 12 PostsJust got a Voile SB Mojo and have the bindings set up and all that. I’m having a problem with the slider pins going through the 2nd hole when I’m setting the board up for “ride” mode. They go through the 1st hole fine but they are a bitch getting them lined up to slide through the 2nd. I’m assuming that I may need to tweak the pucks just a bit to line up better? I’m using the puck alignment guide when I adjust the angle so they should be lined up right, correct?Any suggestions would be greatly appreciated. November 29, 2009 at 9:47 pm #622521 Shep 525 PostsI’ve said this in a couple other places… squeeze the pucks together really hard when you are tightening down the screws. usually does the trick. November 30, 2009 at 3:25 am #622522 mtengaio 12 PostsYeah, I tried that right after I posted and it worked great. Thanks for the reply. Viewing 3 posts - 1 through 3 (of 3 total)You must be logged in to reply to this topic.
