Forums Splitboard Talk Forum DIY Spitting Questions
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #566930
    geoffj
    2 Posts

    Hi Folks,
    Just been splitting my old board and have some questions I haven’t found answers to on the other posts here. Perhaps some of those with experience will have some comments and suggestions.
    Firstly, on bevelling the edge after sawing the board: what is the purpose of this and what size (how much material) should be taken off with the bevel? (A photo or diagram here would be great)
    Also on countersinking the T-nuts: how deep are people countersinking, do you try and leave the nut flush with the surface or countersink deeper (how deep) and fill? Does everyone use epoxy to fill or is there some better material to fill with?
    Also I have found that all the 3/4″ wood bits I found had a point that would cut deeper around the circumference of the countersink; has anyone found a source for bits that drill a “flat” hole? Does it even matter?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.