Forums The Gear Room clip skins Viewing 6 posts - 1 through 6 (of 6 total) Author Posts April 27, 2011 at 8:03 pm #574802 jerrett 139 Posts Anyone ever try these or anything like these, on a splitboard? http://www.clipskins.com/ April 28, 2011 at 2:55 am #639802 jimw 1421 Posts See this post. Never heard anything more about it, so I dunno if the split-specific changes ever materialized. May 15, 2011 at 7:02 pm #639803 rightsider 150 Posts What would be the benefit over using tail clips? May 16, 2011 at 9:42 pm #639804 jimw 1421 Posts Those skins don’t use glue! So all of the hassles related to glue go away. May 16, 2011 at 10:28 pm #639805 jerrett 139 Posts The Gecko Skins look interesting too…not sure where to get em though May 17, 2011 at 9:34 pm #639806 tiltedworld 406 Posts @jerrett wrote: The Gecko Skins look interesting too…not sure where to get em though The US/Can distributor contact is on this page. http://www.gecko.co.at/Gecko_Distributor.html The guy is based in Stowe, VT. I spoke with him over the phone and he said there is a splitboard application. They are just getting started over here in the states. They do cost more than the tractor skins and he quoted me $195 a set. I told him I wanted to demo them before I bought if I was going to be the guinea pig. There was supposed to be a Tahoe rep that was just starting (this was in Feb), but I never got a call back. I was actually in VT in early March and tried to reach him, but never got a hold of him. Who knows – seems like vaporware to me at this point. Viewing 6 posts - 1 through 6 (of 6 total) You must be logged in to reply to this topic.