I assume I am not the only one to notice but couldn't find any feedback so I am putting it out there.
In the video "http://www.splitboard.com/index.php/featured/news/279-prior-splitboard-set-up-video" at ~1:36 when explaining the installation of the "thin plastic shim" under the heel riser the explanation is incorrect. They advise to install the shim with the flat section toward the nose. If the shim is installed this way you cannot use the crampons in fixed mode. The wire ends will also be very close to the shim edge and have less surface support/contact. Also the Voile-USA stamping on the shim would be upside down.
Sent Prior an email; I assume the video is new?
I apologize in advance if the above is already known/on the forum somewhere.
_________________ What a burning need we all have, just to have a burning need...