Splitboard.com Forums

Does anyone know if the Blaze bindings are compatible with Voile DIY pucks?

Calgary split
They will fit.
The only problem you will have is the total overall length issue.
Voile and Spark are slightly different in term of the distance from one end of the puck setup to the other.
The Spark length is slightly shorter.
See what I'm talking about here

The best way around this I've found is to remove a little bit of the puck on the heal side on the back facing edgeas shown above. I know these aren't the Voile puck but there is no difference in the way they work
This will allow you to use both Spark and Voile.
This is due to the Voile stop being in the middle and Spark being on the outside at the rear face.
I would put the pin in the Spark binding and measure the distance form it to the rear stops.
Then measure the Voile DIY mounting template and you will see there is a small difference.
If you need any more help let me know and I may knock up a template for you.

Cheers

@ first line - look at the picture and see the littel difenet backside corners.....



I build last time 50 set s of this custum Pucks there work fine at all systems - the secret is the diferent end line - high and low.
Voile slider and light rail binders youse the top stop, R&D binders youse the down stop line.





markus aka burton from wildschnee