Splitboard.com Forums

The World's first exclusive splitboard discussion forums






It is currently Fri Sep 19, 2014 11:10 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: slider pin on plate
PostPosted: Sun Nov 29, 2009 1:51 pm 
Offline

Joined: Sun Nov 15, 2009 8:51 pm
Posts: 17
Just got a Voile SB Mojo and have the bindings set up and all that. I'm having a problem with the slider pins going through the 2nd hole when I'm setting the board up for "ride" mode. They go through the 1st hole fine but they are a bitch getting them lined up to slide through the 2nd. I'm assuming that I may need to tweak the pucks just a bit to line up better? I'm using the puck alignment guide when I adjust the angle so they should be lined up right, correct?

Any suggestions would be greatly appreciated.


Top
 Profile  
 
 Post subject: Re: slider pin on plate
PostPosted: Sun Nov 29, 2009 2:47 pm 
Offline

Joined: Sat Feb 04, 2006 8:59 am
Posts: 549
Location: Stowe, VT
I've said this in a couple other places... squeeze the pucks together really hard when you are tightening down the screws. usually does the trick.


Top
 Profile  
 
 Post subject: Re: slider pin on plate
PostPosted: Sun Nov 29, 2009 8:25 pm 
Offline

Joined: Sun Nov 15, 2009 8:51 pm
Posts: 17
Yeah, I tried that right after I posted and it worked great. Thanks for the reply.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  





Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group