I am new to splitboarding, and I just got a Prior Brandywine. I have the problem that I cannot turn the chinese hooks in a way that they don't stick out in touring mode. More precisely, I can partially turn one, a stronger friend can turn 2 more (hardly), and one doesn't move at all. I tried loosening it, but I can only get the whole screw to turn in the board, which doesn't sound good.
I am wondering if it is best to just let the hooks stick out during touring, or if there is a way to loosen them? If I let them stick out, I am afraid that an icy chunk might hit them and turn them, and I won't be able to turn it back on the top of the mountain.
Joined: Sat Mar 19, 2011 6:48 pm Posts: 670 Location: Kodiak, AK
The allen wrench size for the Chinese hook bolt head on the bottom of the board is 3/32". Hold this bolt in place with the correct size allen key, and then loosen the nut on the top side of the board holding the center of the Chinese hook in place. Turn the nut, not the bolt. Once you have loosened it a little, grab the Chinese hook with a crescent wrench tightened down on the vertical fin of the Chinese hook, and wiggle it to free it up. It should break free and move easily assuming it is not glued down and you have loosened the bolt. Once it moves you can spray a little silicone lubricant on the deck at the Chinese hook, and then snug the nut down again until you reach the desired resistance. They should be fairly snug so that they can't move on their own, but not too tight so that you can't turn them with medium finger pressure.
_________________ Jones Solution 163W Venture Zephyr 164/260 Never Summer SL 163X Burton Spliff 148 Voile Mojo RX 166 BD, G3, and Gecko skins Sparks!