Post subject: 10/11 Spark Blaze not fitting on Voile Universal pucks?
Posted: Mon Sep 17, 2012 9:36 pm
Joined: Fri Mar 25, 2011 2:04 pm Posts: 7 Location: Colorado Springs, CO
Hiya all; just attempted to mount brand-new 10/11 Spark Blazes using brand-new Voile Universal kit on brand-new Venture; damn binding pins will not fully engage in ride mode. Pins strike forward edge/pucks preventing movement past approx 1in. Used puck-alignment tool and verified Sparks are fully seated against rear pucks on tight Venture. Was this a typical problem on 1st gen Blazes? Can only think of sanding down forward puck slightly-Any other ideas? thanks...
Post subject: Re: 10/11 Spark Blaze not fitting on Voile Universal pucks?
Posted: Mon Sep 17, 2012 10:52 pm
Joined: Sat Mar 19, 2011 6:48 pm Posts: 675 Location: Kodiak, AK
The Voile puck alignment tool only gets you 'close', but not perfect. I always need to tweak my puck positions after getting them roughed-in with the Voile tool. Usually scootching the pucks towards each other a millimeter or so does the trick. Just set them with the Voile tool, then check the binding fit, then loosen the puck screws enough that you can slide it a hair, and finally snug it down and check again.
_________________ Jones Solution 163W Venture Zephyr 164/260 Never Summer SL 163X Burton Spliff 148 Voile Mojo RX 166 BD, G3, and Gecko skins Sparks!