Post subject: problems with t.rice split and spark crampons.
Posted: Thu May 16, 2013 6:31 am
Joined: Wed Apr 29, 2009 7:34 am Posts: 28
Hi guys! I bought a t.rice split, Spark blaze lt and Mr Chomps crampons. I start working on my new toy adjusting everything and when I try to set one of the brakets of the lt system that come with 3 screws, I couldn´t do it in the beginning. Ther other braket fits ok, but this one was a piece of work. I don´t know if its an error on the distances of the holes of the board, or if something happen with the braket. The thing is that when finally I installed it, I tryed to set the crampons, I put them and when I move the binding up and down to see how it works, the crampon touch the edge of the board. Just a little bit, but you can hear and see how the crampon touch and scrach the edge. Someone had the same problem? The only thing I can do is try to open the crampon a little bit, and hope I dont break it!
I have done mods to sparks crampons bending the teeth in a saw like pattern without causing any damage or weakness to them. Just don't over do it to the point they start cracking. They are aluminum after all.