Joined: Wed Jan 04, 2012 2:59 am Posts: 216 Location: Amsterdam
Is that like a 3x3 insert with 4 inserts in the centreline on each foot? Because that sounds like a bad plan. Your saw will try to rip out the insert, depending on what saw you use up to a point. But even if you do manage to get a clean cut you still have to fill up 8 "holes" per side.
If you must use this board, I would drill them out first to about 8mm or untill you see wood. Fill the holes with a thin epoxy (maybe mixed with microfibres or another filler). Do this BEFORE you cut the board, and hopefully the saw will cut clean through the epoxy filled holes leaving you with a clean cut on both sides.
I've not done this myself, so don't curse me if it doesn't work.
_________________ Libtech Dark Series DIY Split with DIY binders Furberg 167 Split with Afterburners Furberg 162 Split with Magnetos