Splitboard.com Forums

The World's first exclusive splitboard discussion forums






It is currently Wed Aug 20, 2014 2:05 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: WTB old Burton interface binding base plates
PostPosted: Fri Sep 21, 2012 11:06 am 
Offline

Joined: Fri Sep 21, 2012 10:29 am
Posts: 4
I have the older style splitboard made by Burton with the older interface kit. I am really in need for two extra baseplates that mount to the bottom of the binding. Anyone help me or point me in the right direction?


Top
 Profile  
 
 Post subject: Re: WTB old Burton interface binding base plates
PostPosted: Mon Sep 24, 2012 9:05 am 
Offline

Joined: Wed Nov 30, 2005 3:32 pm
Posts: 357
http://www.chair2boardsports.com/produc ... ding-pucks

this might be the right direction for an old burton hole pattern board :wink: , take one of the puck blanks, trace where you want it to be on the board, then cut a piece of paper the same size as the puck blank, place it on the board, mark the holes, then transfer those marks to the puck blank, drill and cut the puck blank into two pieces so it overlaps a little on each board half to make you board more rigid.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  





Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group