I'm new to splitboarding and just bought a Prior 168 splitboard. I spent all night last night getting it "just right".
But the Voile binding plate has to be yanked pretty hard to get it on and off the pucks. Not REALLY hard, but hard enough to have bent back a couple of fingernails and split open some knuckes while practicing. Is this normal?
I know I want the tolerances to be tight there, so I'm not going to modify anything, but am curious if people lube or wax those babies to make them slide off and on easier? I was thinking of using Pedro's Ice Wax, the stuff I use on my bike chain. What do you all think?
Joined: Thu Dec 02, 2004 4:26 pm Posts: 407 Location: S.F. Bay Area
Sure, why not. Waxing the track should be fine. And not to worry, it will get easier as you use it as well. Consider it part of the break-in process. There is only you can do with the perfect alignment of the pucks...
had mine for two years and still have issues with sliding off, but only when it's dry. once in the snow and lubed up it seems to slide a little easier. still takes some force though. give it some mustahd!
Joined: Thu Nov 11, 2004 8:18 pm Posts: 270 Location: Bishop, Ca
Try using a bit of fine grain sandpaper on the pucks. Sometimes there are slight irregularities in the plastic that can catch on the metal track. Lightly sand down the tops, as well as the sides.
Another problem could be the length of the screws that are attaching your bindings. If the screws hang down too far below the metal track, they can catch/dig into the plastic pucks. If this is happening, just use two washers for each screw.
Just used my new Voile for the first time. Sprayed the pucks with PAM before going out. Everything worked smooth as could be the first time out. No reason for them to "break in" at all in my situation.