Splitboard.com Forums

The World's first exclusive splitboard discussion forums






It is currently Sun Nov 23, 2014 12:47 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Canting Voile Pucks
PostPosted: Wed Oct 12, 2005 4:19 pm 
Offline

Joined: Wed Oct 12, 2005 3:58 pm
Posts: 0
Location: Kanada
I was wondering if anyone has come up with a good way to create some canting under the pucks on a voile system to make splitting with hard boots more workable. I've tried cutting up some UHMW plastic, (big thick cutting board) but it is tough to get the angles correct on both pucks so that the slider plate will actually slide on without a battle. The other thing that bothers me is the bolt heads (longer replacements) now hit the puck so that only part of the bolt head is in contact. Should I try to mill the the puck where the bolt head sits so it's flush with the bolt head, or am I spending too much time worrying about it? Just trying to avoid equipment failure when I'm going to be a chopper ride and a week away from the car.[/b]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: Baidu [Spider] and 17 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  





Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group