Splitboard.com Forums

what are you canting your bindings with hardbooters?

what degrees do you cant to?

I use the toe and heel blocks of the F2 Race Titanium binding on a Voile slider. I am able to use the cant and lift system from the original binding. Currently I still have a supply of the older 5.5mil bails. Now the F2 Race Titanium comes with 5.9mil.

I am not positive of the amount that I cant, but it is the smallest amount possible using the stock wedges. I have slight inward cant on both the front and back foot.

what about with voile mountain plates or burton race plate mod?

I use 2.5 degree cant wedges from tognar tools with the RacePlate mod bindings. This makes the TLT5 boot shafts neutral when clipped in, as they have built in cant for skiing (which helps them split ski a little better).
Sognar's thread on the RacePlate bindings shows these cants (in the binding forum).

christoph
I'm running 5 on the rear foot.
Play with the front now, will tell later in our season.

Cheers

I use cut up pieces of voile gasket. Double stacked in the way back. Triple double up front.

you make the canted pucks right?
any chance you make those in 2 or three degree cant?



i thought about using rubber to dampen the ride a bit...was thinking old pieces of tire filed down to the right angle...

I used these plastic shims http://www.acehardware.com/product/inde ... 5010543964 from Ace to shim my Burton race plates on Voile sliders. Just trimmed to fit and drilled some holes. Easy.

christoph
I was just doing 5 degrees to start with.
I have had people asking for other angles.
I was going to do 2.5 degrees on the next run.

Cheers