Splitboard.com Forums

Just got a Voile SB Mojo and have the bindings set up and all that. I'm having a problem with the slider pins going through the 2nd hole when I'm setting the board up for "ride" mode. They go through the 1st hole fine but they are a bitch getting them lined up to slide through the 2nd. I'm assuming that I may need to tweak the pucks just a bit to line up better? I'm using the puck alignment guide when I adjust the angle so they should be lined up right, correct?

Any suggestions would be greatly appreciated.

I've said this in a couple other places... squeeze the pucks together really hard when you are tightening down the screws. usually does the trick.

Yeah, I tried that right after I posted and it worked great. Thanks for the reply.