Splitboard.com Forums

The World's first exclusive splitboard discussion forums






It is currently Sat Aug 30, 2014 5:41 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: R and D compatible with Volie DIY
PostPosted: Sat Aug 06, 2011 11:03 pm 
Offline

Joined: Wed Jul 27, 2011 10:29 pm
Posts: 14
Does anyone know if the Blaze bindings are compatible with Voile DIY pucks?


Top
 Profile  
 
 Post subject: Re: R and D compatible with Volie DIY
PostPosted: Sun Aug 07, 2011 12:34 am 
Offline
User avatar

Joined: Fri Feb 22, 2008 6:51 am
Posts: 691
Location: Surfing or Splitboarding Downunder
Calgary split
They will fit.
The only problem you will have is the total overall length issue.
Voile and Spark are slightly different in term of the distance from one end of the puck setup to the other.
The Spark length is slightly shorter.
See what I'm talking about here
Image
The best way around this I've found is to remove a little bit of the puck on the heal side on the back facing edgeas shown above. I know these aren't the Voile puck but there is no difference in the way they work
This will allow you to use both Spark and Voile.
This is due to the Voile stop being in the middle and Spark being on the outside at the rear face.
I would put the pin in the Spark binding and measure the distance form it to the rear stops.
Then measure the Voile DIY mounting template and you will see there is a small difference.
If you need any more help let me know and I may knock up a template for you.

Cheers

_________________
Adam West
Board Designer
FirstLight
+61 (0)413 888 115
http://www.firstlightsnowboards.com.au http://www.splitfest.com.au http://www.splitfests.com http://www.mrbc.com http://www.backcountryglobal.com
Sydney - Nowra - Jindabyne


Top
 Profile  
 
 Post subject: Re: R and D compatible with Volie DIY
PostPosted: Sun Aug 07, 2011 2:56 am 
Offline
User avatar

Joined: Thu Nov 18, 2004 1:08 pm
Posts: 378
Location: near munich
@ first line - look at the picture and see the littel difenet backside corners.....

Image

I build last time 50 set s of this custum Pucks there work fine at all systems - the secret is the diferent end line - high and low.
Voile slider and light rail binders youse the top stop, R&D binders youse the down stop line.

Image



markus aka burton from wildschnee

_________________
life`s too short not to be


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: Bing [Bot], Google [Bot] and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  





Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group