Forums DIY and Mods K-Clip Hardware Viewing 3 posts - 1 through 3 (of 3 total) Author Posts December 1, 2015 at 9:14 am #786638 snowsnowsnow 54 Posts So in the process of switching over to K-clips I stripped out two of my Voile screws. I picked up a set of the K-Clip hardware and then realized the shape of the screw head is more conical than flat like the Voile screws. The Karakoram screws don’t quite sit flat as Venture drilled the space out for the flat headed Voile screws. For those of you with K-clips, has anyone had success drilling space our for the different shape screws or should I just track down some more Voile screws? December 2, 2015 at 3:10 am #786681 Matt Wood 328 Posts I would imagine you could drill it with a 3/8″ countersink bit, but they would probably sit below the base. Why the switch to K clips? After 5 or so seasons using K clips I just switched back to voile hooks, There way better IMO. December 2, 2015 at 7:59 am #786694 snowsnowsnow 54 Posts I picked up a set of super cheap prime bindings over summer and decided to give them a shot. Since they don’t like to play well with the hooks I grabbed the K clips. Viewing 3 posts - 1 through 3 (of 3 total) You must be logged in to reply to this topic.