Forums DIY and Mods Cants Re: Don’t do this…. anywhere! May 5, 2006 at 2:03 am #588652 Jon Dahl 384 Posts I did mine in my table saw! I did risk a finger doing it, and highly recommend against that method, but I was desperate to “get ‘er done”. You would need a two axis vise, and hold the block by the area that would be the thickest finished part. Much scratching of head and puzzled looking should get you there! PS Jack, won’t your mill at school have a vise like this, or a head that will work on two axis’ at the same time?