Forums Splitboard Talk Forum Ignition II crampon question Reply To: Ignition II crampon question June 25, 2008 at 4:41 pm #606617 jbaysurfer 947 Posts OMG HOW STUPID CAN YOU BE!!!! 😆 J/K….here’s a link to the setup guide. http://www.sparkrandd.com/wp-content/uploads/2008/05/ignition-binding-setup-guidex1.pdf in laymans terms, with the binding in touring mode, lift up the heel of the binding, slide the chomps in and the little plastic (pu whatever) bar goes between the binding and the touring bracket. Slides in and out without removing the binding, the geometry locks it in pretty good. Also, make sure to remove the original plastic inserts in your touring bracket (little gray plastic dealios) and replace with the flat (probably black) ones that will sends you along w/ the crampons….hope this helps!